機械社區

標題: 牧野機床出現以下問題，哪個大神幫忙解決 [打印本頁]
作者: 朱一濱    時間: 2015-7-30 16:52
標題: 牧野機床出現以下問題，哪個大神幫忙解決
牧野機床出現以下問題，哪個大神幫忙解決。多謝了！) N. f7 p; W$ s* X

- I5 ]" j0 ~& J5 M& C9 Z機床問題：
# a- J3 q; W" q3 N, }) a
9 v2 f( w- _' [8 [# o5 E# Q- y1、SPNDL SPEED COMMAND IS NOT SET WHEN START SW，WAS PRESSED
! ^8 j1 K1 N) _: v0 L/ Z
! N  Z' u4 P, [1 Q8 Z: R6 J! iCOMMAND S—CODE AFTER RESET ALARM1 W1 b' C. q+ q: M

3 [" E( }4 a/ Z2、NOZZLE CLANT THERMAL RELAY IS TRIPPED
) U+ x2 t4 k! X" {2 m; q6 ]: }5 U
) Y1 \+ S# D( N# V+ d; Y7 pDI SIGNAL TH2... WENT ON% F+ w0 `6 ~" U; ]2 y5 K

0 l; `0 Q9 D; D- J0 nCHECK THERMAL RELAY AND THE BREAKER' x8 N" ^+ e3 [1 B+ I( N

8 F' k% [+ {, H, ^$ G2 r; k7 K3、NC ALAMRE IS BEING GENERATED: [4 \/ y. _3 g

; V9 f$ F. _1 `, Z# m; L8 B3 GBMI SIGNAL AL....IS ON7 P7 ~+ ]4 N+ k3 h0 L  l( [  A

' G0 Z% t) _% h& D7 T# B/ o5 [+ PCHECK FAULTY DEVICE
4 Y; }* u7 f# J; E$ }6 P* C3 ?4 b' U) u+ v1 K6 `
4、TOOL CLAMP SIGNAL TOOK OFF DURING SPINDLE CW ROTATION DI SIGNAL LS00..IS OFF
- f' {7 e" r( }! W, \+ D3 K
$ u. G& v: [6 B3 O6 Q, dCHECK THE CONDITION OF LIMIT SWITCH，SILENOID AND ETC
- ^9 V" v6 P- ~2 c- `
' G5 Z1 `  V( Y0 |1 u6 U: I5、MAN. TOOL UNCLAMP & CLAMP CANNOT PERFORM AT AUTO MODE) x: J( c/ A' u/ L( k0 Z7 D

9 y" s0 E( k* n: e# ESELECT CORRECT CODE
6 v7 G4 Q' t( A9 [1 C7 Q( K



歡迎光臨 機械社區 (http://e-learninguniversity.com/) Powered by Discuz! X3.4