|
|
本帖最后由 hlhchina 于 2011-11-30 21:38 編輯
6 T% a3 u! U5 v! o2 G" `# l y4 M( t4 }0 ~2 R% ]- ^0 ], w
我在做金屬切削仿真，在金屬切削仿真中采用自適應網格，但是在網格檢查時出現自適應不能使用單元畸變控制�。。�7 u$ [) [) [5 t* z
問題描述如下：
1 Q% I% H( R8 Y* T0 `# b$ C$ a: AAdaptive meshing is not supported for elements used with the distortion control. 6 u: N# B7 M, ~% M D* d. I* g% K
Domain name: assembly_adapt
6 `4 \9 \4 V$ k- @8 C, I& ^0 y2 QAbaqus/Explicit Packager exited with an error - Please see the status file for possible error messages if the file exists./ D: ~* b4 \$ l! h% l" x( I- _
; e. A0 K; `" X但是不用網格畸變控制吧，又出現了網格畸變問題：# f, H2 }" X2 c: V J- h
The elements contained in element set ErrElemExcessDistortion-Step1 have distorted excessively.! @4 F& b" N/ _" E. A
The elements in element set ErrElemZeroALEMass-Step1 have zero or negative mass.& ^4 }' J2 f% s( W) X F
Print-out suppressed for subsequent distorted elements
2 A0 `. d0 u# X N& S5 D4 c9 ?There are a total of 60 excessively distorted elements.& o& t5 A5 z3 S; {3 r
請求各位達人幫助，萬分感謝�。�！% @& c/ @- u1 g# w& d0 s( i
|
|
發表于 2011-11-30 20:51:21
QQ好友和群
收藏
淘帖
問題專業，描述清楚
伸手黨/灌水/看不懂
